TELEMAC-MASCARET Forum: What error during the simulation (1/1)

Welcome, Guest

TOPIC: What error during the simulation

Hong	Hi everyone, I am modelling telemac3d hydrodynamics. The upper boundary is the discharge boundary and the download boundary is water level boundary. My calculation stops with an error and I don’t know what it is. It seems that there is no valid information provided in the error file. How can I find the problem? Please see the attached files. Best wishes Hong
	The administrator has disabled public write access.

PMV OFFLINE Expert Boarder Posts: 152 Thank you received: 43	No files attached. Cheers, Patrick
	The administrator has disabled public write access. The following user(s) said Thank You: Hong

Hong	Sorry for the failed uploading. Please see the attached files. Best wishes Hong Attachments: 1_2023-03-17-2.jpg (136KB) 2_2023-03-17-2.jpg (142KB) 3_2023-03-17-2.jpg (96KB) 4_2023-03-17-2.jpg (157KB) 5_2023-03-17-2.jpg (160KB) 6_2023-03-17-2.jpg (69KB)
	The administrator has disabled public write access.

c.coulet OFFLINE Moderator Posts: 3799 Thank you received: 1056	Hi There is a mention of a Floating point exception on image 3. Upgrade to the latest telemac version Use the option checking the mesh ) Yes could gives you some complementary informations Regards
	Christophe The administrator has disabled public write access.

Hong	Thanks for your reply. I'm not sure if the latest telemac version is v8p4r0. Where can I find the installation file? And is there any user mannual about the version? Best wishes Hong
	The administrator has disabled public write access.

Hello Hong,

Currently, v8p4r0 is the latest release.

What do you mean with "installation file)?
You can get instructions for how to install TELEMAC on Linux here:
wiki.opentelemac.org/doku.php?id=installation_on_linux
If using Windows, as already discussed in other topics, you can read:
gitlab.pam-retd.fr/otm/wintel

You can find user manuals here:
wiki.opentelemac.org/doku.php?id=documentation_v8p4r0

Hope this helps,

Chi-Tuan

The administrator has disabled public write access.

Hong	Hello,Chi-tuan Thank you for your reply. The "installation file" I mentioned referred to the former auto-installer. But at present I know tha updating will be supported by Git which I'm not familiar with. I'll try the ways on "gitlab.pam-retd.fr/otm/wintel" and hope it helps~ Best wishes Hong
	The administrator has disabled public write access.